how to show the units on the results.

ounifiras · November 21, 2013, 03:35

how to show the units on the schemas results. I has used> Analysis> 3D> Units> Plotting Units> SI. and I check> Show units on studs, but the results are shown without UNITs, I have not found an explanation?

JBurnham · November 24, 2013, 16:07

You need to set the unit system on the Model Setup > General tab before you run the simulation. Only then can does the output file contain info about what the original units are so that they can be converted or shown on output plots. Otherwise what you did is correct.

AMflow · November 25, 2024, 14:26

Can you change the units of a existing simulation or can you only select units when creating a new analysis case?

November 21, 2013, 03:35	how to show the units on the results.	#1
ounifiras Member ouni firas Join Date: Oct 2013 Posts: 33 Rep Power: 13	how to show the units on the schemas results. I has used> Analysis> 3D> Units> Plotting Units> SI. and I check> Show units on studs, but the results are shown without UNITs, I have not found an explanation?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem: Very long "write" time (~2h-3h) for results and transient results	Shawn_A	CFX	16	April 12, 2016 20:49
Lost Scenario Results..??	Fugacity	Autodesk Simulation CFD	1	February 24, 2012 10:48
[OpenFOAM] ParaFOAM 3Dwindow doesnbt show results continuously	dresi	ParaView	1	February 19, 2009 23:19
Circular miniFlume experimental amp numerical results	amelia	OpenFOAM Running, Solving & CFD	11	September 4, 2005 22:42
To dimensionalize or not to dimensionalize !!	tolani owosina	Main CFD Forum	8	November 13, 1999 13:45

November 24, 2013, 16:07		#2
JBurnham Senior Member Jeff Burnham Join Date: Apr 2010 Posts: 204 Rep Power: 18	You need to set the unit system on the Model Setup > General tab before you run the simulation. Only then can does the output file contain info about what the original units are so that they can be converted or shown on output plots. Otherwise what you did is correct.

November 25, 2024, 14:26		#3
AMflow New Member Join Date: Nov 2024 Posts: 1 Rep Power: 0	Can you change the units of a existing simulation or can you only select units when creating a new analysis case?