Solver Error
I want to simulate a physical model.
When i click Run simulation, the below message is appear and simulation stop. Solver Messages: convective flux exceeded stability limit at t= 1.2892E-02 cycle= 1 iter= 45 delt= 1.2892E-02 mesh block 1 restarting cycle with smaller time step maximum failure ratio = 1.26154E+01 is in x-coordinate direction at cell ( 78, 10, 10) mesh block 1 Can everyone explain about it?? I'm stuck....:confused: |
Hi, Go to:
Help>>Content>>Troubleshooting>>diagnostic Message>>Solver Message and find your solver message.there are good explanation. |
All times are GMT -4. The time now is 12:16. |