Rainfall modeling using source volume flow rate

max0014 · October 31, 2012, 17:29

Hi,
I am trying to model rainfall runoff simulation using FLOW-3D. But the version 10.0 does not have a way to input rainfall hence I used volume flow rate in Geometry>component>component properties.
However the flow rate at the outflow boundary is not correct and shows fluctuations which should not be the case.

Is it because of the rainfall input process or do I have to change some other parameters to reduce fluctuations at the outflow.Is there a way to input rainfall other than this?

Thank you,
Max

chaitanyaarige · November 24, 2016, 03:49

I am working on similar problem. Where fluid is falling in the form of droplets.
Which is best model in Multiphase??
And if anyone was successful in implementing this type of simulation...any other advises are welcome. (I am using ANSYS/openfoam)

October 31, 2012, 17:29	Rainfall modeling using source volume flow rate	#1
max0014 New Member max Join Date: Oct 2011 Posts: 10 Rep Power: 14	Hi, I am trying to model rainfall runoff simulation using FLOW-3D. But the version 10.0 does not have a way to input rainfall hence I used volume flow rate in Geometry>component>component properties. However the flow rate at the outflow boundary is not correct and shows fluctuations which should not be the case. Is it because of the rainfall input process or do I have to change some other parameters to reduce fluctuations at the outflow.Is there a way to input rainfall other than this? Thank you, Max chaitanyaarige likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Other] mesh airfoil NACA0012	anand_30	OpenFOAM Meshing & Mesh Conversion	13	March 7, 2022 17:22
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 06:09
mass flow in is not equal to mass flow out	saii	CFX	12	March 19, 2018 05:21
[swak4Foam] funkySetFields compilation error	tayo	OpenFOAM Community Contributions	39	December 3, 2012 05:18
How to change from mass flow to volume flow rate	stanley	FLUENT	1	February 2, 2007 06:44

November 24, 2016, 03:49		#2
chaitanyaarige New Member Chaitanya Join Date: Aug 2013 Location: Mumbai Posts: 18 Rep Power: 12	I am working on similar problem. Where fluid is falling in the form of droplets. Which is best model in Multiphase?? And if anyone was successful in implementing this type of simulation...any other advises are welcome. (I am using ANSYS/openfoam)