 |
 |
 |
|
|
|
[Sponsors] | ||||
September 13, 2017, 09:32
|
question about fluid2 parameter setting
|
#1 |
|
New Member
王橙
Join Date: Sep 2017
Posts: 1
Rep Power: 0  |
why some parameter that I can not set? I can not click the dark grey blank. New worms help.
|
|
|
|
|
|
November 3, 2017, 03:41
|
|
#2 |
|
Member
nazrin
Join Date: Apr 2016
Posts: 35
Rep Power: 10 |
Hello,
This is because you are using one fluid. To model 2 fluids simulation, you need to tick two fluids button at: Model setup > general > number of fluids. |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| A Question About Setting Whole Velocity Field Using "Proflie" in FLUENT | adsl17754 | FLUENT | 5 | July 31, 2018 04:29 |
| Question about time step setting for different turbulence modeling | Anna Tian | Main CFD Forum | 1 | November 19, 2012 02:09 |
| question regarding the codes for setting inlet flow | Alicelin | OpenFOAM Pre-Processing | 4 | November 11, 2009 03:04 |
| Question about inlet setting | Mahe | Phoenics | 0 | June 12, 2009 23:31 |
| Warning 097- | AB | Siemens | 6 | November 15, 2004 04:41 |
Linear Mode
