Can't edit component properties

AllenSpellwaver · November 2, 2017, 01:56

Hi, I'm just getting into Flow 3D for a college course. I was going through the tutorial and had no problems navigating the ins and outs until the subsection of component properties.

While the tutorial screenshots indicate I am able to edit most of the values in all categories of component properties, they are greyed out on my screen. For example, the tutorial asks me to input values in Thermal Conductivity and Density*Specific Heat, but the respective bars on my screen are greyed out, and values are unable to be changed because of it.

I think this may just be a very minor issue with my property setting, but I'm really stuck here. Can anyone help me solve it?

Thanks.

thunde47 · November 3, 2017, 12:52

Most likely you have not activated relevant physics models in the physics tab, like heat transfer model.

November 2, 2017, 01:56	Can't edit component properties	#1
AllenSpellwaver New Member Chuanli Ni Join Date: Nov 2017 Posts: 1 Rep Power: 0	Hi, I'm just getting into Flow 3D for a college course. I was going through the tutorial and had no problems navigating the ins and outs until the subsection of component properties. While the tutorial screenshots indicate I am able to edit most of the values in all categories of component properties, they are greyed out on my screen. For example, the tutorial asks me to input values in Thermal Conductivity and Density*Specific Heat, but the respective bars on my screen are greyed out, and values are unable to be changed because of it. I think this may just be a very minor issue with my property setting, but I'm really stuck here. Can anyone help me solve it? Thanks.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Lagrangian library: Edit particle properties within force calculation	oswald	OpenFOAM Programming & Development	8	April 5, 2018 11:47
mass flow in is not equal to mass flow out	saii	CFX	12	March 19, 2018 05:21
Adding material to CFX material library	marlon	CFX	2	October 16, 2016 09:33
Laptop for CFD - recommendation	Far	Hardware	20	May 31, 2012 17:01
ParaView Compilation	jakaranda	OpenFOAM Installation	3	October 27, 2008 11:46

November 3, 2017, 12:52		#2
thunde47 Senior Member thunde47 Join Date: Dec 2015 Location: India, USA Posts: 133 Blog Entries: 1 Rep Power: 10	Most likely you have not activated relevant physics models in the physics tab, like heat transfer model.