Pressure iteration did not converge in scour simulation
Hello everyone,
I am writing here to receive your help. I am simulating sour sediment over the cylinder. The simulation with a cylinder at 90 degrees is good. However, when I change the cylinder with 80,70,...30 degrees, the solution does not correct and it said that "pressure iteration did not converge in itmax= 100 iterations". After that, the solution is stopped. I changed the value at multiplier for dynamically adjusted convergence criterion which in pressure solver options>>convergence controls to 100 and 10^6, but that situation continuously occurs. Please help me explain and solve this problem. Thank you in advance. |
Hi Mai Loan,
Try to improve your mesh. Use nested block or confirming mesh. Refer the manual for more information. |
All times are GMT -4. The time now is 11:54. |