|
[Sponsors] |
Set the boundary condition to wall or specified velocity? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 17, 2020, 05:08 |
Set the boundary condition to wall or specified velocity?
|
#1 |
New Member
Zhejiang
Join Date: Jun 2020
Posts: 1
Rep Power: 0 |
Hi everyone,
I am a new in Flow-3D. I want to simulate a droplet's pinch-off dynamics, how to set the boundary condition of the top of model? Wall or specified velocity? Best wishes |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to set a swirling inlet velocity boundary condition | sunyuze0806 | OpenFOAM | 0 | June 16, 2020 02:13 |
Difficulty in calculating angular velocity of Savonius turbine simulation | alfaruk | CFX | 14 | March 17, 2017 06:08 |
Difficulty In Setting Boundary Conditions | Moinul Haque | CFX | 4 | November 25, 2014 17:30 |
Velocity profile boundary condition | Tuca | FLOW-3D | 1 | April 23, 2013 12:02 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |