Post-processing in Flow-3D

nauman maldar · November 11, 2020, 00:37

Hello everyone,
Does anybody know how we can create the type of streamline shown in attached figure using Flowsight? When i try to create pathlines or streamlines, they are like those lengthy ones..i want to create shorter arrows like these shown in picture.

koful · December 30, 2020, 12:32

Hello. These are velocity vectors not streamlines. Try velocity vectors on 2d clips

redlemon44 · August 30, 2022, 10:09

In analyse and display, go to the vector options to change vector settings for a 2d plot (since its a vector plot, not a streamlines). In FLOW-3D POST use the glyphs filter for displaying vectors, described in the FLOW-3D POST reference guide. As of 2021, FLOW-3D POST is the default post processing tool for all FLOW-3D products.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
need TUI or UDF post processing command help.	Ash Kot	FLUENT	4	September 7, 2022 01:41
fluent DPM - post processing ParaView	gigivmasche	FLUENT	4	October 23, 2019 03:05
Post processing journal - like .cst in CFD Post	Jiricbeng	FLUENT	0	April 24, 2019 08:08
is it possible to write post processing UDF or TUI commands to do following task?	Ash Kot	Fluent UDF and Scheme Programming	1	October 7, 2016 05:38
Post processing in Immersed boundaary method with finite difference schemes	casper	Main CFD Forum	6	October 8, 2015 06:05

December 30, 2020, 12:32		#2
koful Member Join Date: Jun 2014 Location: Turkey Posts: 43 Rep Power: 10	Hello. These are velocity vectors not streamlines. Try velocity vectors on 2d clips

August 30, 2022, 10:09		#3
redlemon44 New Member UK Join Date: May 2019 Location: uk Posts: 23 Rep Power: 5	In analyse and display, go to the vector options to change vector settings for a 2d plot (since its a vector plot, not a streamlines). In FLOW-3D POST use the glyphs filter for displaying vectors, described in the FLOW-3D POST reference guide. As of 2021, FLOW-3D POST is the default post processing tool for all FLOW-3D products.