 |
 |
 |
|
|
|
[Sponsors] | ||||
Laser-based powder bed fusion (LPBF) modeling with FLOW-3D |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 5, 2022, 17:45
|
Laser-based powder bed fusion (LPBF) modeling with FLOW-3D
|
#1 |
|
New Member
hamed
Join Date: Sep 2022
Posts: 17
Rep Power: 3  |
Hi
An urgent request I want to model the laser-based powder bed fusion (LPBF) with using Flow3D version 11 software, and I do not have access to the WELD and AM modules. I want to know how to model the moving laser heat flux on the powder surface in the software? As well as the recoil pressure of the laser on the surface? Thanks for reply |
|
|
|
|
|
September 8, 2022, 21:13
|
An urgent request
|
#2 |
|
New Member
hamed
Join Date: Sep 2022
Posts: 17
Rep Power: 3 |
Hi
An urgent request I want to model the laser-based powder bed fusion (LPBF) with using Flow3D version 11 software, and I do not have access to the WELD and AM modules. I want to know how to model the moving laser heat flux on the powder surface in the software? As well as the recoil pressure of the laser on the surface? Thanks for reply |
|
|
|
|
|
|
December 20, 2022, 09:26
|
I have same question
|
#3 |
|
New Member
Join Date: Dec 2022
Posts: 1
Rep Power: 0 |
||
|
|
|
|
|
| Tags |
| flow 3d, heat flux model, laser powder bed fusion, recoil pressure |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Open channel flow over porous bed, interface roughness | narendrapatel111 | Fluent Multiphase | 0 | July 5, 2017 22:17 |
| PhD in turbulence | Hans | Main CFD Forum | 14 | October 8, 2001 03:03 |
| CFD Modeling of Two-phase Flow in Small Dia.Tubes | Eric Poindexter | Main CFD Forum | 2 | September 22, 2000 09:21 |
| fluid flow fundas | ram | Main CFD Forum | 5 | June 17, 2000 21:31 |
| Hydrostatic pressure in 2-phase flow modeling (long) | DS & HB | Main CFD Forum | 0 | January 8, 2000 15:00 |
Linear Mode
