 |
 |
 |
|
|
|
[Sponsors] | ||||
Mass Source: Total Flow Rate vs Per Unit Area Flow Rate |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 31, 2022, 03:26
|
Mass Source: Total Flow Rate vs Per Unit Area Flow Rate
|
#1 |
|
New Member
Im
Join Date: Jul 2022
Posts: 5
Rep Power: 3  |
In the mass source option, I want to specify the volume flowrate, but there is two options here
1. Total flow rate 2. Per unit area flowrate. May I know what is the difference between those two? Is it differs in terms of unit? Is the unit for per unit area flowrate is (m3/s/m2 = m/s?) |
|
|
|
|
|
| Tags |
| mass source term, per unit area flow rate |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Multiphase flow - incorrect velocity on inlet | Mike_Tom | CFX | 6 | September 29, 2016 01:27 |
| what is swap4foam ?? | AB08 | OpenFOAM | 28 | February 2, 2016 01:22 |
| [Other] How to use finite area method in official OpenFOAM 2.2.0? | Detian Liu | OpenFOAM Meshing & Mesh Conversion | 4 | November 3, 2015 03:04 |
| [Other] Adding solvers from DensityBasedTurbo to foam-extend 3.0 | Seroga | OpenFOAM Community Contributions | 9 | June 12, 2015 17:18 |
| SparceImage v1.7.x Issue on MAC OS X | rcarmi | OpenFOAM Installation | 4 | August 14, 2014 06:42 |
Linear Mode
