|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
kyla
Join Date: May 2024
Posts: 13
Rep Power: 2 ![]() |
I need to simulate a channel. Only the inlet boundary condition= velocity and water elevation is given. There is no reservoir that is why I did not put initial condition. However, in the results, there is no water generated.
I also tried to put initial condition on the inlet but there is still no water generated. What do I need to do? |
|
![]() |
![]() |
![]() |
![]() |
#2 |
New Member
kyla
Join Date: May 2024
Posts: 13
Rep Power: 2 ![]() |
I also tried pressure with elev boundary but still, there is no water
|
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Floating point exception error | lpz_michele | OpenFOAM Running, Solving & CFD | 53 | October 19, 2015 03:50 |
Cannot run the code properly: very large time step continuity error | crst15 | OpenFOAM Running, Solving & CFD | 9 | December 14, 2014 19:17 |
Unstabil Simulation with chtMultiRegionFoam | mbay101 | OpenFOAM Running, Solving & CFD | 13 | December 28, 2013 14:12 |
calculation stops after few time steps | sivakumar | OpenFOAM Running, Solving & CFD | 7 | March 17, 2013 07:37 |
Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 05:03 |