Greetings from Australia
Hello from Australia to all the Flow-3D users out there! It's great to see we finally have a 'home' at CFD Online.
By way of introduction: I have been using Flow-3D for about 7.5 years now, mostly for open channel flow in hydraulic structures (spillways, intakes, outfalls, pump stations, fish passages etc), and I've also used it for the occasional blast analysis or ventilation study. Looking forward to being a part of the forum! Cheers, Karen Riddette (Senior Engineer / Analyst) WorleyParsons Advanced Analysis, Sydney, Australia |
Re: Greetings from Australia
Dear Karen Riddette I am ali etesam.I want to model an Ogee spillway 3D with FLOW-3D ver8.2. But How can do that? Please help me. Thanks
Best regards |
Re: Greetings from Australia
Hi Ali,
You should start by looking at the example model of 'Flow over a weir' to understand how the boundaries and initial conditions should be set up. Then you need to modify the example to include your Ogee crest geometry. I usually create a 3D STL file using third-party modelling software and import it into Flow-3D. Cheers, Karen Ps - you might want to upgrade your software too, there have been a lot of improvements since v8.2! |
Re: Greetings from Australia
Hi Karen I know that at firs step should study exampels i did that. Thank you very much.
|
My research is pump stations. I want to put pump in the simulation, and i was using fan and impeller mode but the flow behind the impeller was not ture. would you sent me some cases about this model? thank you very much. i do appreciate it
my email 403761912@qq.com |
All times are GMT -4. The time now is 02:26. |