Reef breakwater

kost_st · March 10, 2010, 04:14

Hi. I would like simulate a reef breakwater with Flow 3d in order to check the significant height at the upwind and downwind place of the breakwater. I would like to know if somebody has done something similar. Thanks.

ignatz · March 10, 2010, 13:58

Hello Kost,
I am not sure if anyone has done exactly what you hope to model, but I can tell you there was a presentation in the Tokyo user's conf. last year by INA Corp that addressed something similar. And there have been a number of studies of using devices to break tsunami waves both in this same conference in earlier years as well as in other user conferences. Perhaps you might contact Flow science directly to see about getting these?

kost_st · March 16, 2010, 07:10

Hi. I would like to know whether somebody knows the way to specify the wave height with flow3d.

March 10, 2010, 04:14	Reef breakwater	#1
kost_st New Member Join Date: Mar 2010 Posts: 2 Rep Power: 0	Hi. I would like simulate a reef breakwater with Flow 3d in order to check the significant height at the upwind and downwind place of the breakwater. I would like to know if somebody has done something similar. Thanks.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
harbour and breakwater for numeca	youcef benali	Fidelity CFD	0	January 28, 2006 12:01

March 10, 2010, 13:58		#2
ignatz Member Join Date: Jan 2010 Posts: 39 Rep Power: 16	Hello Kost, I am not sure if anyone has done exactly what you hope to model, but I can tell you there was a presentation in the Tokyo user's conf. last year by INA Corp that addressed something similar. And there have been a number of studies of using devices to break tsunami waves both in this same conference in earlier years as well as in other user conferences. Perhaps you might contact Flow science directly to see about getting these?

March 16, 2010, 07:10		#3
kost_st New Member Join Date: Mar 2010 Posts: 2 Rep Power: 0	Hi. I would like to know whether somebody knows the way to specify the wave height with flow3d.