|March 16, 2010, 08:54||
Annoying Beginner Problem
Join Date: Mar 2010
Posts: 1Rep Power: 0
I am just learning how to drive Flow 3d, and I am using the example they have called "Flow over a weir".
I can get the preprocessing to work, but the solver comes up with an error and wont run, as follows.
"forrtl: severe (66): output statement overflows record, unit -5, file Internal Formatted Write
Image PC Routine Line Source
hydr3d.exe 009F68F2 Unknown Unknown Unknown
Stack trace terminated abnormally.
214Solver Terminal Error"
I have shortened the file name as much as possible (its very short) and it IS the correct version ie 32bit on vista 32bit.
Does anyone have any ideas why the solver crashes like this???
|March 22, 2010, 22:08||
Join Date: Mar 2009
Posts: 332Rep Power: 10
|Thread||Thread Starter||Forum||Replies||Last Post|
|UDF compiling problem||Wouter||Fluent UDF and Scheme Programming||6||June 6, 2012 04:43|
|Incoherent problem table in hollow-fiber spinning||Gianni||FLUENT||0||April 5, 2008 10:33|
|natural convection problem for a CHT problem||Se-Hee||CFX||2||June 10, 2007 06:29|
|Adiabatic and Rotating wall (Convection problem)||ParodDav||CFX||5||April 29, 2007 19:13|
|problem with using colocated code||Jack||Main CFD Forum||0||December 15, 2002 01:15|