the big problem about flow3dMP
hello everyone:I am now using flow3d9.4MP,and I have a big problem.when i runpre_par,the result is like that
"processing geometry components processing non-moving component 1 in mesh block 1 1 rank 0 in job 56 node1_35234 caused collective abort of all ranks exit status of rank 0: killed by signal 9 PREP3D complete",the runpre failed. but when I use his example 'mblock',it runpre well and tells that " processing geometry components processing non-moving component 1 in mesh block 1 processing non-moving component 1 in mesh block 2 processing non-moving component 1 in mesh block 3 total and active cell counts: 25494 10666 " I really do not understand it,please help me ,thank you very much! |
have you looked in the pre-processor output files, such as prpout or prperr, on each rank?
|
All times are GMT -4. The time now is 12:45. |