DPM - Particle Concentration and Associated Mass Flow Rate

Jeremiah · April 1, 2014, 17:47

Hi,

I would really appreciate some help on this. I am modelling a slurry flow and I need to vary the sand concentration.

I was basically wondering the best way to do this, I was told to do concentration by volume but I think at the inlet (there is only one inlet). For 1% sand concentration I was going to use a surface injection at the inlet with a mass flow rate equal to 1% of the water mass flow rate, but this seems like a crude method.

Does anyone know the best way to do this? Thanks a lot.

Ahmed Tamkin · April 3, 2014, 05:42

This might help
http://wenku.baidu.com/view/b51ef307eff9aef8941e062f

I'm looking for slurry flow aswell.

April 1, 2014, 17:47	DPM - Particle Concentration and Associated Mass Flow Rate	#1
Jeremiah New Member Jeremiah Join Date: Apr 2014 Posts: 1 Rep Power: 0	Hi, I would really appreciate some help on this. I am modelling a slurry flow and I need to vary the sand concentration. I was basically wondering the best way to do this, I was told to do concentration by volume but I think at the inlet (there is only one inlet). For 1% sand concentration I was going to use a surface injection at the inlet with a mass flow rate equal to 1% of the water mass flow rate, but this seems like a crude method. Does anyone know the best way to do this? Thanks a lot.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

April 3, 2014, 05:42		#2
Ahmed Tamkin New Member Ahmed Tamkin Butt Join Date: Apr 2014 Posts: 4 Rep Power: 10	This might help http://wenku.baidu.com/view/b51ef307eff9aef8941e062f I'm looking for slurry flow aswell.