[toufik08]

Hi all,
I'm trying to simulate water in oil droplet using typical géometry (t-junction, where diamter of oil channel is double of diamter of water channel), i used VOF model, surface tension is 0.003 N/m, as boundary condition i have tried pressure inlet and velocity inlet.
For discret phase model i have used droplet breakup.
i don't know why i havn't obtained droplet breakup.
which are the important parameters that i have to verify?? should I change boundary conditons????
thank you so much

[Sarvyyy]

Hi , have you find the answers ? I'm working on this now and I have so many problems

[toufik08]

Originally Posted by Sarvyyy

Hi , have you find the answers ? I'm working on this now and I have so many problems

I didn't receive any reply, but I since one year or more I found solution and I have published several papers with VOF simulation of droplet breakup

[CeesH]

Also recommended: http://journals.cambridge.org/action...22112013000189

(Hoang, D et al., JFM 717 (2013))

[Jophie]

Originally Posted by toufik08

Hi all,
I'm trying to simulate water in oil droplet using typical géometry (t-junction, where diamter of oil channel is double of diamter of water channel), i used VOF model, surface tension is 0.003 N/m, as boundary condition i have tried pressure inlet and velocity inlet.
For discret phase model i have used droplet breakup.
i don't know why i havn't obtained droplet breakup.
which are the important parameters that i have to verify?? should I change boundary conditons????
thank you so much

Hello, do you mind sharing with me how you went on with this work? Thank you