multiphas flow in double pipes

kh91 · April 18, 2014, 14:26

Hi
I am trying to model a two phase flow which is consist of vertical double pipe tube. Very hot gas is flowing through the inner pipe and water is the fluid of outer pipe. The water will be vaporized by the heat of the gas and steam bubbles will be appeared. Gas does not have any phase change ; just becomes cooler. I use the mixture model for two phase flow consist of water and steam. Am i right? If not which model is suitable for this case?
The next question is that when i define the gas, in Boundary Condition , fluent activates the 3phases: mixture, phase1 and phase2‎ for gas, while the gas doesn't have any phase change.How can i fix this?
Thanks in advance.

gerardosrez · November 11, 2014, 14:39

Hi kh91,

Could you solve your problem??

I am going to perform the same simulation. I am working on the mesh right now, but I will be facing this later

Thanks in advance...

April 18, 2014, 14:26	multiphas flow in double pipes	#1
kh91 New Member azadehkhalili Join Date: Apr 2014 Posts: 5 Rep Power: 12	Hi I am trying to model a two phase flow which is consist of vertical double pipe tube. Very hot gas is flowing through the inner pipe and water is the fluid of outer pipe. The water will be vaporized by the heat of the gas and steam bubbles will be appeared. Gas does not have any phase change ; just becomes cooler. I use the mixture model for two phase flow consist of water and steam. Am i right? If not which model is suitable for this case? The next question is that when i define the gas, in Boundary Condition , fluent activates the 3phases: mixture, phase1 and phase2‎ for gas, while the gas doesn't have any phase change.How can i fix this? Thanks in advance. Amir A likes this.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Help with if statement	CHARLES	OpenFOAM Programming & Development	17	August 22, 2021 03:14
Gate valve flow simulations...	nikesh	FloEFD, FloWorks & FloTHERM	5	January 28, 2014 01:31
wired error in openfoam	conceptone	OpenFOAM	4	August 7, 2012 15:45
Inlet Boundary Conditions to model Slug flow in pipes	A.Salih	FLUENT	6	August 3, 2012 16:31
Annular Flow in Pipes	metro	OpenFOAM Running, Solving & CFD	0	August 11, 2010 03:34

November 11, 2014, 14:39		#2
gerardosrez Member G. S. Join Date: Nov 2010 Posts: 54 Rep Power: 15	Hi kh91, Could you solve your problem?? I am going to perform the same simulation. I am working on the mesh right now, but I will be facing this later Thanks in advance...