 |
 |
 |
|
|
|
[Sponsors] | ||||
December 6, 2014, 21:22
|
Fluent not patching in the right way
|
#1 |
|
Member
G. S.
Join Date: Nov 2010
Posts: 54
Rep Power: 15  |
Hello Fluent users,
I am trying to patch the half volume of a 3d region.... I use the following strategy (as per tutorials) 1. Adapt-->Region-->Mark 2. Solution Initialization-->Initialize 3. Patch I check the marked region and it is good, but when I plot a contour with the Volume fraction I see that all the volume has been patched with the value specified for the secondary phase (VOF model by the way).... Have you had similar problem... Best regards... |
|
|
|
|
|
January 19, 2015, 02:51
|
You may have patching problem.
|
#2 |
|
Member
Join Date: Jul 2012
Location: India
Posts: 32
Rep Power: 13 |
There are two options are available on patch window. First one is FLUID and another one is 'WHAT YOU HAVE PATCHED'. So select only one of them. Check your co-ordinates etc in ADAPT window.
Hope this will solve your problem. |
|
|
|
|
|
|
February 13, 2015, 21:11
|
|
#3 |
|
Member
G. S.
Join Date: Nov 2010
Posts: 54
Rep Power: 15 |
THanks it solved my problem...
|
|
|
|
|
|
 |
| Tags |
| fluent, patch, vof, volume fraction |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 03:22 |
| heat transfer with RANS wall function, over a flat plate (validation with fluent) | bruce | OpenFOAM Running, Solving & CFD | 6 | January 20, 2017 06:22 |
| patch error OF v2.2.2 mac | hewei | OpenFOAM Installation | 4 | November 30, 2013 16:55 |
| Fluent 6.3 32bit vs Fluent 12.0 64bit | ibex7 | FLUENT | 7 | April 18, 2011 02:44 |
| Fluent 12.0 is worst then Fluent 6.2 | herntan | FLUENT | 5 | December 14, 2009 02:57 |
Linear Mode
