 |
 |
 |
|
|
|
[Sponsors] | ||||
Time delayed input for multiphase model in Fluent |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 16, 2015, 15:12
|
Time delayed input for multiphase model in Fluent
|
#1 |
|
New Member
Rakibul Islam
Join Date: Jul 2015
Posts: 6
Rep Power: 10  |
Hi
I am a beginner in Fluent. I am working on multi-phase (water and air) model where water and air are coming to a vessel from two different direction and different path. I know the mass flow rate at the inlets for water and air. In my case water is injected 7 seconds earlier than the injection of air. Is it possible to to provide any time delay between the two inputs? If it is possible , any help regarding time delay input will be highly appreciated. Regards Rakib |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Elastic or Plastic Deformations in OpenFOAM | NickolasPl | OpenFOAM Pre-Processing | 36 | September 23, 2023 08:22 |
| High Courant Number @ icoFoam | Artex85 | OpenFOAM Running, Solving & CFD | 11 | February 16, 2017 13:40 |
| Hardware-Configuration for Fluent HPC-Pack (8x) | JohHaas | Hardware | 9 | March 3, 2015 13:25 |
| Unstabil Simulation with chtMultiRegionFoam | mbay101 | OpenFOAM Running, Solving & CFD | 13 | December 28, 2013 13:12 |
| Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 04:03 |
Linear Mode
