Temperature doesn't match the volume of fluid
Hello everybody,
I'm carrying out a simulation where a fluid (a polymer) enters to a cavity. I carry out a VOF simulation and I obtain the following 'Phase 2: Volume of fluid' result at a particular time step: http://s18.postimg.org/ltbo3lowp/Capture1.png What I don't think it's correct, is that the profile temperature is, at the same time step of the previous snapshot, the following one: http://s27.postimg.org/xztl0hv2r/capture2.png My common sense says that the Temperature result should show something similar to the VOF result, with a sharp interface between the polymer and the air temperatures. Thanks in advance! |
Please... No one find this weird?
|
Please attach snapshot of contours.
|
All times are GMT -4. The time now is 08:05. |