Home > Forums > Software User Forums > ANSYS > FLUENT > Fluent Multiphase

Multiphase Simulation (Oil Water Interface)

Mark Forums Read

Reply

Search this Thread

October 27, 2017, 07:22	Multiphase Simulation (Oil Water Interface)	#1
Sripadaraja New Member Sripadaraja Join Date: Sep 2015 Posts: 23 Rep Power: 9	Hi I am a beginner in ANSYS- FLUENT. i am working on a microchannel (Flow Focusing Device). I believe I have set all the simulation settings correctly to perform the multiphase flow. I have set the simulation time 0.1m sec. Until 0.05m sec I can see the flow. Further, I am unable to see flow beyond the cross junction. It appears it has hit the dead end. What could be the reason? I am unable to upload the zipped file as it is over 53MB. -Sripad

Reply

Tags

droplet microfluidics, micro channel, microfluidic, multiphase flow

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind turbine simulation	Saturn	CFX	58	July 3, 2020 01:13
Basic Nozzle-Expander Design	karmavatar	CFX	20	March 20, 2016 08:44
Setting rotating frame of referece.	RPFigueiredo	CFX	3	October 28, 2014 04:59
Fluid-Solid Interface Settings for a Rotating Water Container	r.mojtaba	CFX	4	October 14, 2013 19:01
Question about heat transfer coefficient setting for CFX	Anna Tian	CFX	1	June 16, 2013 06:28

All times are GMT -4. The time now is 12:53.