 |
 |
 |
|
|
|
[Sponsors] | ||||
Access the area and normal of the interface in VOF |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 6, 2018, 04:56
|
Access the area and normal of the interface in VOF
|
#1 |
|
New Member
Pan Aniu
Join Date: Mar 2018
Location: Wuhan
Posts: 7
Rep Power: 9  |
Hi Experts,
For VOF problem in Ansys Fluent, after the position of the linear interface is calculated by the Geometric Reconstruction Scheme, how can I access the area and normal of the interface. Additionally, I wonder whether the Geometric Reconstruction Scheme is used to calculate the position of the interface at initialization when UDF is used to specify the volume-of-fluid in each cell. |
|
|
|
|
|
| Tags |
| ansys fluent, free interface, geometric reconstruction, vof |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] snappyHexMesh error "Cannot determine normal vector from patches." | lethu | OpenFOAM Meshing & Mesh Conversion | 1 | June 3, 2020 08:49 |
| How to get area, face normal vector of a patch | GCMS_A | OpenFOAM Running, Solving & CFD | 2 | September 16, 2018 12:20 |
| Question about adaptive timestepping | Guille1811 | CFX | 25 | November 12, 2017 18:38 |
| Error - Solar absorber - Solar Thermal Radiation | MichaelK | CFX | 12 | September 1, 2016 06:15 |
| RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 05:05 |
Linear Mode
