Floating Point Exception Error

Madinah123 · November 3, 2019, 14:10

I am simulating nozzle inside tank. After meshing the domain in ANSYS Mechanical Workbench and Importing in Fluent, I am constantly getting the following message "floating point exception" in calculation.

Please can somebody solve my problem?

I am attaching some mesh images below:

Mesh Statistics:

No of elements : 473600

Element Size : 10 mm

Minimum Element Skewness: 1.3057e-010

Maximum Element Skewness: 0.50

Minimum Element Quality: 1.3695e-002

Maximum Element Quality: 0.83662

Minimum Aspect Ratio: 1.847

Maximum Aspect Ratio: 19.32

Maximum Orthogonal Qualify: 0.73972

Maximum Orthogonal Qualify: 1

Anyone Please Help..

rupak504 · November 5, 2019, 11:17

Mostly these kinds of errors occur if you have given any unphysical condition in your problem. or if there is problem in boundary conditions.

November 5, 2019, 11:17		#2
rupak504 Senior Member Lolita Join Date: Aug 2016 Posts: 115 Rep Power: 9	Mostly these kinds of errors occur if you have given any unphysical condition in your problem. or if there is problem in boundary conditions. Jeffer likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Undeclared Identifier Errof UDF	SteveGoat	Fluent UDF and Scheme Programming	7	October 15, 2014 07:11
[General] 2 datas on one plot	Akuji	ParaView	46	December 1, 2013 14:06
Floating point error and divergence detected	aannjj	FLUENT	0	July 2, 2013 03:44
[swak4Foam] groovyBC: problems compiling: "flex: not found" and "undefined reference to ..."	sega	OpenFOAM Community Contributions	12	February 17, 2010 09:30
[Gmsh] Gmsh and samplesurface	touf	OpenFOAM Meshing & Mesh Conversion	2	December 10, 2007 02:27