Missing Option on Display
1 Attachment(s)
Hello everyone,
I cannot see the plot option in the mass flow rate in fluent 2019 R2. Is it something wrong in the settings of Fluent R2 or it is default? Because I can find it in R3. Thanks in advance. |
Plot
You may define the plot separately under Report Plot.
|
Missing Plot Option
2 Attachment(s)
Yeah, I have searched for it. I am attaching the pics of ansys 2019 19.2, as you can see there is no option.
Once you by mistakenly close the window, then we should simulate again for the results as there is no plot option. Is this common or there is any settings? |
Plot
The plot is already defined. The options are just extra. With newer versions, plot is a separate entity. As you observe that it is defined under Report Plots. So, it already is a plot.
|
Option to regenerate closed window
So, is there a way to regenerate the plot, once the window is closed by mistake after simulation?
|
Plot after simulation
If Fluent saved the data within data file, then you just need to run for 1 iteration and the plot will show. Usually, Fluent does not do that. Hence, if you did not write it out as an external file, plot is gone.
|
Oh Okay. I'll try it.
Thank you Vinerm Raj |
All times are GMT -4. The time now is 11:30. |