How to write UDF for moving sesh

Saidul · October 20, 2015, 22:44

Hi All,
I have just started with moving mesh and I need to write a UDF for my model. I am simulating air flow in a straight pipe and my geometry has two parts. I have created a layer inside the geometry. I need to move the mesh inside the layer and the mesh movement will be opposite of the air flow. Can anyone tell me how can I do that.

Please see the attached image for clear idea.

Thank you very much for your help.

Regards,
saidul;

zg8 · December 2, 2015, 23:33

hi,I saw this post a minute ago.and I am also doing this work.Have you solved the problem?Looking forward to your reply.Thnak you!

Saidul · December 6, 2015, 23:06

Sorry mate, I am still trying to do that.......

moabdi · December 7, 2015, 06:52

Hi saidul

it's simple if your movement is along pipe axis, in fluent/cell zone condition, you could see "mesh motion" option and enter direction of motion.
but, why you want to move the mesh?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Linux commands to write udf for remote Linux nodes	saayo3	Fluent UDF and Scheme Programming	4	November 1, 2017 07:14
HOW to write udf for motion of piston and displacer?	mani.rajendiran	Fluent UDF and Scheme Programming	0	March 13, 2012 01:22
Fluent write UDF for calculating My, Mz and Fz	davesmith_01	FLUENT	1	November 20, 2011 22:20
how to write a 3D linear temperature of UDF	venus	FLUENT	1	October 28, 2008 03:46
UDF TO WRITE OUT DATA!!	Aishwarya	FLUENT	0	August 12, 2004 11:11

December 2, 2015, 23:33		#2
zg8 New Member zg Join Date: Dec 2015 Posts: 2 Rep Power: 0	hi,I saw this post a minute ago.and I am also doing this work.Have you solved the problem?Looking forward to your reply.Thnak you!

December 6, 2015, 23:06		#3
Saidul Member S. Morichika Join Date: Aug 2014 Posts: 62 Rep Power: 13	Sorry mate, I am still trying to do that.......

December 7, 2015, 06:52		#4
moabdi New Member mohsen Join Date: Jun 2015 Posts: 25 Rep Power: 12	Hi saidul it's simple if your movement is along pipe axis, in fluent/cell zone condition, you could see "mesh motion" option and enter direction of motion. but, why you want to move the mesh?