Problem with building 3ddp UDF in Ansys FLUENT 16.2

SPH_CFD · July 18, 2016, 12:46

Dear all,

I have a strange problem. First, I run 2D with UDF (2ddp_host and 2ddp_node), everything is built and run as normal.
After that I start 3D model with the same UDF and copy libudf from 2D cases with adding 3ddp, 3ddp_host and 3ddp_node. I do not understand why I cannot build it and get this message

make[1]: Entering directory `path/libudf/lnamd64/3ddp'
makefile:14: user.udf: No such file or directory
make[1]: *** No rule to make target `user.udf'.
make[1]: Failed to remake makefile `user.udf'.
# Generating udf_names.c because of makefile

I try the same folder with 2ddp is OK.

Could you give me advices about this problem?
Thank you in advance.

Bruno Machado · July 20, 2016, 05:08

you gotta compile it again for 3D case.

July 18, 2016, 12:46	Problem with building 3ddp UDF in Ansys FLUENT 16.2	#1
SPH_CFD Member Quang Le Dang Join Date: Jun 2012 Posts: 61 Rep Power: 15	Dear all, I have a strange problem. First, I run 2D with UDF (2ddp_host and 2ddp_node), everything is built and run as normal. After that I start 3D model with the same UDF and copy libudf from 2D cases with adding 3ddp, 3ddp_host and 3ddp_node. I do not understand why I cannot build it and get this message make[1]: Entering directory `path/libudf/lnamd64/3ddp' makefile:14: user.udf: No such file or directory make[1]: *** No rule to make target `user.udf'. make[1]: Failed to remake makefile `user.udf'. # Generating udf_names.c because of makefile I try the same folder with 2ddp is OK. Could you give me advices about this problem? Thank you in advance.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem with an old Simulation	FrankW	CFX	3	February 8, 2016 05:28
how to understand UDF in ansys fluent?	sriyaz	Fluent UDF and Scheme Programming	4	November 10, 2015 03:27
Problem using ANSYS Fluent 15.07	Saikat_FM	FLUENT	2	July 13, 2015 06:10
The fluent stopped and errors with "Emergency: received SIGHUP signal"	yuyuxuan	FLUENT	0	December 3, 2013 23:56
fluent udf problem: write specific data for every iteration in a file.	nnvoro	Fluent UDF and Scheme Programming	1	May 27, 2013 16:26

July 20, 2016, 05:08		#2
Bruno Machado Senior Member Bruno Machado Join Date: May 2014 Posts: 271 Rep Power: 14	you gotta compile it again for 3D case.