Boundary condition for UDS

lconstantin · September 22, 2016, 05:31

Hi all,
I have a 2D case for an airfoil, and want to hook a UDF to it, just to test if I am on the right path with writing it. The mesh cells are rectangular. I have identified in my UDF the 2 orthogonal normal vectors for each cell near the airfoil boundary, in order to offer me the local (airfoil) coordinate system. In order to do this, I have created 6 UDSs: 3 for the x direction (X and Y components and magnitude) and 3 for the y direction (same as for x). What boundary conditions should I set for these, in order to plot these vectors in post-processing?
Thank you!

pakk · September 26, 2016, 03:49

I think you are using the wrong tool: you don't want UDS, but UDM. No boundary conditions are needed for a UDM.

September 22, 2016, 05:31	Boundary condition for UDS	#1
lconstantin New Member Join Date: Sep 2016 Posts: 9 Rep Power: 8	Hi all, I have a 2D case for an airfoil, and want to hook a UDF to it, just to test if I am on the right path with writing it. The mesh cells are rectangular. I have identified in my UDF the 2 orthogonal normal vectors for each cell near the airfoil boundary, in order to offer me the local (airfoil) coordinate system. In order to do this, I have created 6 UDSs: 3 for the x direction (X and Y components and magnitude) and 3 for the y direction (same as for x). What boundary conditions should I set for these, in order to plot these vectors in post-processing? Thank you!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
Centrifugal fan	j0hnny	CFX	13	October 1, 2019 13:55
Accessing multiple boundary patches from a custom boundary condition file	ripudaman	OpenFOAM Programming & Development	0	October 22, 2014 18:34
Radiation interface	hinca	CFX	15	January 26, 2014 17:11
An error has occurred in cfx5solve:	volo87	CFX	5	June 14, 2013 17:44

September 26, 2016, 03:49		#2
pakk Senior Member Join Date: Nov 2013 Posts: 1,965 Rep Power: 25	I think you are using the wrong tool: you don't want UDS, but UDM. No boundary conditions are needed for a UDM.