|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
abhay
Join Date: Aug 2010
Posts: 9
Rep Power: 16 ![]() |
Hello All,
I was trying to create a UDF for electrical conductivity in a multiphase MHD simulation using DEFINE_PROPERTY. While the UDF gets compiled and loaded. It gives me an error as soon as I initialize/run or try to plot electrical conductivity. This is not working even if I give a constant as return in the UDF. The error I get is , "Error: received a fatal signal (Segmentation fault)." I am using 17.1. Thanks in anticipation. |
|
![]() |
![]() |
![]() |
![]() |
#2 | |
Senior Member
Bruno Machado
Join Date: May 2014
Posts: 271
Rep Power: 13 ![]() |
Quote:
Check if all the information you use in your UDF is available. |
||
![]() |
![]() |
![]() |
![]() |
#3 |
New Member
abhay
Join Date: Aug 2010
Posts: 9
Rep Power: 16 ![]() |
Hi,
Thanks for the response. I have checked that. I just tried returning a constant value from UDf but it still did not work. In fact, the same udf when applied to any other material property is working but not for elec cond. |
|
![]() |
![]() |
![]() |
Tags |
electrical conductivity, fluent - udf, mhd, udf |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDF for thermal conductivity relation of nano fluid | ngonbadipoor@yahoo.com | Fluent UDF and Scheme Programming | 29 | April 1, 2017 04:02 |
I need one simple udf code for effective thermal conductivity of nanofluid | mvf | Fluent UDF and Scheme Programming | 1 | February 10, 2017 20:05 |
Serial UDF is working for parallel computation also | Tanjina | Fluent UDF and Scheme Programming | 0 | December 26, 2013 19:24 |
UDF is working in Laptop, but not working in Serial Cluster | Tanjina | Fluent UDF and Scheme Programming | 0 | December 20, 2013 22:42 |
Can wemodify effective thermal conductivity by UDF | FengYun | FLUENT | 2 | October 27, 2005 06:28 |