 |
 |
 |
|
|
|
[Sponsors] | ||||
November 6, 2020, 21:22
|
setting of UDS
|
#1 |
|
Senior Member
Join Date: Feb 2020
Posts: 114
Rep Power: 6  |
If I don't need to set boundary values in some places, do I just keep the default setting which is "Specified Flux equals zero"?
|
|
|
|
|
|
November 9, 2020, 00:12
|
|
#2 |
|
Senior Member
Alexander
Join Date: Apr 2013
Posts: 2,363
Rep Power: 34 |
fast answer is yes.
however, the real answer comes from concept of the model you are going to simulate. Actually, you should know from the very begging what are boundary conditions in your model
__________________
best regards ****************************** press LIKE if this message was helpful |
|
|
|
|
|
 |
| Tags |
| uds |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| using chemkin | JMDag2004 | OpenFOAM Pre-Processing | 2 | March 8, 2016 22:38 |
| setting UDS Flux | Andrew Garrard | FLUENT | 9 | February 10, 2015 13:26 |
| [snappyHexMesh] determining displacement for added points | CFDnewbie147 | OpenFOAM Meshing & Mesh Conversion | 1 | October 22, 2013 09:53 |
| Cells with t below lower limit | Purushothama | Siemens | 2 | May 31, 2010 21:58 |
| Warning 097- | AB | Siemens | 6 | November 15, 2004 04:41 |
Linear Mode
