ANSYS: How to read Scheme file and change the boundary conditions

Betelhiem · May 29, 2021, 15:02

Hello,

I am new to ANSYS and CFD. I was trying to change the boundary conditions of transient and Laminar simulation using a scheme file. The scheme file has properties such as inlet velocity and temperature. I have successfully imported the mashed geometry to the solver, and tried to read the scheme file using the step file > read > scheme, then choose my file. I can see that the scheme file goes through when the console shows me the message Done #f. But the problem is the boundary conditions are not changing even after reading the scheme file, I don’t know what its problem is. If anyone out there notices my mistake I would appreciate your help and suggestions.

Thank you very much!
Betelhiem

pakk · May 30, 2021, 01:37

It sounds like you did OK, and the scheme file needs to be adjusted.
But, how can we tell without seeing the scheme file???

AlexanderZ · May 30, 2021, 20:08

copy first line of your scheme to fluent console, press enter
check, if it was executed according to your needs.

make it for the whole your code

May 29, 2021, 15:02	ANSYS: How to read Scheme file and change the boundary conditions	#1
Betelhiem New Member Betelhiem Join Date: May 2021 Posts: 4 Rep Power: 4	Hello, I am new to ANSYS and CFD. I was trying to change the boundary conditions of transient and Laminar simulation using a scheme file. The scheme file has properties such as inlet velocity and temperature. I have successfully imported the mashed geometry to the solver, and tried to read the scheme file using the step file > read > scheme, then choose my file. I can see that the scheme file goes through when the console shows me the message Done #f. But the problem is the boundary conditions are not changing even after reading the scheme file, I don’t know what its problem is. If anyone out there notices my mistake I would appreciate your help and suggestions. Thank you very much! Betelhiem

May 30, 2021, 01:37		#2
pakk Senior Member Join Date: Nov 2013 Posts: 1,965 Rep Power: 26	It sounds like you did OK, and the scheme file needs to be adjusted. But, how can we tell without seeing the scheme file??? __________________ "The UDF library you are trying to load (libudf) is not compiled for parallel use on the current platform" is NOT the error after compiling. It is the error after loading. To see compiler errors, look at your screen after you click "build".

May 30, 2021, 20:08		#3
AlexanderZ Senior Member Alexander Join Date: Apr 2013 Posts: 2,363 Rep Power: 34	copy first line of your scheme to fluent console, press enter check, if it was executed according to your needs. make it for the whole your code __________________ best regards ****************************** press LIKE if this message was helpful

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[swak4Foam] swak4foam for OpenFOAM 4.0	mnikku	OpenFOAM Community Contributions	80	May 17, 2022 08:06
Wind turbine simulation	Saturn	CFX	58	July 3, 2020 01:13
what is swap4foam ??	AB08	OpenFOAM	28	February 2, 2016 01:22
centOS 5.6 : paraFoam not working	yossi	OpenFOAM Installation	2	October 9, 2013 01:41
Error finding variable "THERMX"	sunilpatil	CFX	8	April 26, 2013 07:00