 |
 |
 |
|
|
|
[Sponsors] | ||||
December 31, 2014, 13:16
|
connecting two faces by UDF
|
#1 |
|
New Member
Ayse Ozdogan
Join Date: Oct 2014
Posts: 4
Rep Power: 11  |
Dear Friends,
I am doing heat transfer analyses for the borehole heat exhanger and my CFD model has fluid flowing through the U-pipe. I have a U-pipe but not geometrically connecting at the bottom (two pipe side by side).So, is there any way to connect these two pipe at the bottom to get continues flow through the pipe. Thanks and happy new year!! |
|
|
|
|
|
January 14, 2015, 12:43
|
|
#2 |
|
Member
Join Date: Nov 2014
Posts: 31
Rep Power: 11 |
As per description I am assuming that outflow of one pipe is the inflow of another.If it is the case you don't need UDF
You can try periodic non conformal interface..You may need to use translational periodic.. Check it out if it helps... |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Loop over the faces of a cell in UDF | Anthony Wachs | Fluent UDF and Scheme Programming | 6 | April 2, 2024 10:10 |
| decomposePar no field transfert | Jeanp | OpenFOAM Pre-Processing | 3 | June 18, 2022 12:01 |
| Cluster ID's not contiguous in compute-nodes domain. ??? | Shogan | FLUENT | 1 | May 28, 2014 15:03 |
| [Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem | Attesz | OpenFOAM Meshing & Mesh Conversion | 12 | May 2, 2013 10:52 |
| [blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 07:36 |
Linear Mode
