 |
 |
 |
|
|
|
[Sponsors] | ||||
Slow overwriting of parameter values when Fluent is opened |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 10, 2015, 05:18
|
Slow overwriting of parameter values when Fluent is opened
|
#1 |
|
New Member
Join Date: Jul 2012
Posts: 2
Rep Power: 0  |
Hi,
I am running a fluent simulation with about 160 input-parameters. The simulation is controlled by Excel VBA and I need to calculate many cases. At first I tried to run the Workbench Update() command, but the loading and initialization took much longer than the calculation itself. Now I tried to keep Fluent open and start the simulation with SendCommand(Command="/solve/iterate 1000"). This works pretty well, but when the fluent case is open, the changing of the input-paramter values in workbench takes about 100 seconds. If fluent is closed this only takes about 3 seconds. So is there a way to keep the fluent simulation open and speed up the overwriting of the input-parameters? |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question about Fluent monitor and input parameter | Anna Tian | FLUENT | 6 | March 19, 2015 10:17 |
| The fluent stopped and errors with "Emergency: received SIGHUP signal" | yuyuxuan | FLUENT | 0 | December 3, 2013 22:56 |
| Ansys FLUENT UDF - Velocity profile (of known values) across edge / surface | emmkell | Fluent UDF and Scheme Programming | 2 | October 21, 2011 13:12 |
| shear rate values with fluent | Iñigo | Main CFD Forum | 0 | October 17, 2005 06:25 |
| Getting values from fluent solver | Moshiur R. Chowdhury | FLUENT | 2 | November 27, 2002 13:41 |
Linear Mode
