3d centrifugal pump analysis in fluent_turbo
Hi....
I have been working in the flow analysis of centrifugal pump. I tried to enable the turbo topology in fluent but was getting error "Not Valid Topology: Not defined" I am doing a full impeller attached with the casing analysis. i have defined the following boundary condition for turbo topology HUB - hub CASING - shroud THETA PERIODIC - THETA MIN - THETA MAX - OUTLET - impeller interface with casing BLADES - impeller blades for the full 3D analysis should i specify any theta min and max could any one help me...... Thanks in advance Manuvel |
All times are GMT -4. The time now is 20:21. |