 |
 |
 |
|
|
|
[Sponsors] | ||||
May 8, 2012, 06:02
|
invalid command
|
#1 |
|
New Member
Manjunath
Join Date: Mar 2012
Location: HUBLI
Posts: 20
Rep Power: 15  |
after typing the below command
define/models/dynamic-mesh-controls /define/models/dynamic-mesh-controls> and pressing enter. it is showing invalid command as > define/models/dynamic-mesh-controls /define/models/dynamic-mesh-controls> invalid command [dynamic-mesh-controls>] so please help me |
|
|
|
|
|
May 8, 2012, 06:18
|
|
#2 |
|
Senior Member
Join Date: May 2011
Location: Germany
Posts: 130
Rep Power: 16 |
Did you first activate dynamic mesh?
define/models/dynamic-mesh "Enable dynamic mesh?" YES "Enable in-cylinder model?" YES/NO "Enable 2.D model?" YES/NO "Enable Six DOF model?" SEY/NO and then: define/models/dynamic-mesh-controls |
|
|
|
|
|
|
May 8, 2012, 09:10
|
|
#3 |
|
Senior Member
xrs333
Join Date: Aug 2010
Posts: 125
Rep Power: 18 |
Do not include ">" in the command.
|
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| OpenFOAM 1.7.1 installation problem on OpenSUSE 11.3 | flakid | OpenFOAM Installation | 16 | December 28, 2010 09:48 |
| Installation OF1.5-dev | ttdtud | OpenFOAM Installation | 46 | May 5, 2009 03:32 |
| OpenFOAM15 installables are incomplete problem with paraFoam | tryingof | OpenFOAM Bugs | 17 | December 7, 2008 05:41 |
| Regarding FoamX running Kindly help out | hariya03 | OpenFOAM Pre-Processing | 0 | April 18, 2008 05:26 |
| Phase locked average in run time | panara | OpenFOAM | 2 | February 20, 2008 15:37 |
Linear Mode
