evaporation and condensation in Fluent
Now I want to simulate evaporation and condensation in heat pipe, and I want to use the evaporation-condensation model in Fluent 14.0.
I did a case in which vapor goes through a pipe with a lower temperature level, there is no water appearing. Do any one have the experience of using this model? Is there some things should I pay attention to? and is there any examples? Any help will be apperiated! |
Tell me the details you are using to set up the case
|
Do you know about condensation and evaporation in heat pipes? I had a try with UDF, and the results were not so good. Can I have your e-mail address? so I can talk with you in time.
|
|
|
All times are GMT -4. The time now is 12:48. |