3D Gas Turbine Combustor

February 9, 2004, 15:36

Hi I am using fluent 6 for modeling a 3d gas turbine combustor.(Kerosen+air) I want to solve it firstly with cold flow but i dont know why i have reverse flow even in inlet.The dimensions are taken from lab.i was thinking that it is related to the lenght of combustor.i changed it but i still have the same problem. Whenever i change the flow direction from component to normal to boundary the revese flow will disapear. actually i want to see the swirling flow arround the air swireler. So you are kindly requested to help me with this concern. 2. i am not able to set my viscous model boundary condition for air swirling. Regards

juzer_700 · May 18, 2012, 05:17

Hey, I'm trying to simulate combustion chamber (cold flow) in ANSYS FLUENT> BUt it is showing reverse flow. I am actually simulating in 2D-Axisymmetrical. I want to see the effect of swirl, so I mentioned the swirl number.

Am I doing anymistake.
Did you manage to correct your simulation and succeded in doing it?

Please reply.

February 9, 2004, 15:36	3D Gas Turbine Combustor	#1
Ehsan Alborzi Guest Posts: n/a	Hi I am using fluent 6 for modeling a 3d gas turbine combustor.(Kerosen+air) I want to solve it firstly with cold flow but i dont know why i have reverse flow even in inlet.The dimensions are taken from lab.i was thinking that it is related to the lenght of combustor.i changed it but i still have the same problem. Whenever i change the flow direction from component to normal to boundary the revese flow will disapear. actually i want to see the swirling flow arround the air swireler. So you are kindly requested to help me with this concern. 2. i am not able to set my viscous model boundary condition for air swirling. Regards

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Gas Turbine combustor inlet boundary condtions	jose_rodrig	OpenFOAM	3	May 18, 2012 07:13
simulate a gas turbine combustor with dieselFoam	kikko	OpenFOAM	0	September 23, 2011 20:32
pressure drop in gas turbine combustor	hosein azadi	Site Help, Feedback & Discussions	1	June 8, 2010 10:20
Gas Turbine Combustor Data	cfd_user	CFX	0	August 10, 2000 16:40
Gas Turbine Combustor Data	cfd_user	FLUENT	0	August 10, 2000 16:37

May 18, 2012, 05:17		#2
juzer_700 Member Join Date: Apr 2012 Location: Mainz, Germany Posts: 60 Rep Power: 14	Hey, I'm trying to simulate combustion chamber (cold flow) in ANSYS FLUENT> BUt it is showing reverse flow. I am actually simulating in 2D-Axisymmetrical. I want to see the effect of swirl, so I mentioned the swirl number. Am I doing anymistake. Did you manage to correct your simulation and succeded in doing it? Please reply.