|
2-D analysis of textured converging slider geometry
Hi everyone,
I am a student of Indian Institute Of Technology-BHU, India. I am doing a fluid flow analysis(pressure and load capacity calculation) for a textured micro thrust bearing. Basically there are two walls, one above another making a convergent spacing between them. lower wall has partial periodic rectangular texturing. Upper wall is moving with constant velocity and lower one is stationary and in between the fluid film. Now i have to do 2-D analysis of the problem but with 2-D i am unable to do the proper "named selection" of surfaces, as here in 2-D surfaces look like a line. so this way i have stuck here. please kindly post some advice for me.. |
| All times are GMT -4. The time now is 17:27. |