Home > Forums > Software User Forums > ANSYS > FLUENT

Simulation of a brick

Mark Forums Read

Reply

Search this Thread

June 20, 2012, 06:14	Simulation of a brick	#1
stage81 Member Join Date: Sep 2010 Posts: 60 Rep Power: 17	I have a 3D brick (10cm10cm10cm) open of the top face and other feces represents walls. I want to fill with water to a hof the faceeight of 2cm only, how can I do to set the water level in my brick? Is what I defined the mesh inside the brick's intill my desired level of water?

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Why my simulation not agree with the wind tunnel experiment	zhaowei	CFX	4	July 11, 2015 04:36
Solar Radiation in OpenFOAM	plainstyle	OpenFOAM Running, Solving & CFD	15	July 8, 2014 05:43
Simulation of a complex wing in solidworks flow simulation	niels1900	FloEFD, FloWorks & FloTHERM	6	April 20, 2011 11:44
Continuous vs interrupted simulation	sega	OpenFOAM Running, Solving & CFD	4	November 3, 2008 15:29
strange simulation error	Ralf Schmidt	FLUENT	2	May 4, 2007 14:02

All times are GMT -4. The time now is 05:54.