|June 20, 2012, 07:13||
outlet-vent pressure adaption
Join Date: May 2011
Posts: 130Rep Power: 7
following case (see: http://www.cfd-online.com/Forums/flu...daption.html):
I do have 3 pressure-vent outlets. At the end I want to have a specific mass flow rate at each outlet (-+5%). If I use target mass flow rate my calculations crash (pressure is adapted every time step, right?)
So I want somehow a function (UDF?) which check the mass flow after 1000 iterations. If it is within a limit its fine, if not the pressure should be adapted (lets say old_pressure - 1000) ... and this gain every 1000 iterations ...
Can you help me with this? I had no experience with UDF so far and I just did it manually (stop after 1000 iterations, check mass flow, change pressure) ...
|Thread||Thread Starter||Forum||Replies||Last Post|
|operation pressure and pressure outlet BC||Lilly||FLUENT||4||May 8, 2013 09:57|
|ZeroGradient pressure Outlet BC prob (adjustPhi.C)||Stylianos||OpenFOAM||3||March 23, 2010 13:28|
|steam flow in a pipe driven by a pressure gradient between inlet and outlet||SalvoCalvo||Main CFD Forum||0||March 11, 2010 07:52|
|Pressure Rise Error||emueller||CFX||0||May 5, 2009 11:08|
|Hydrostatic pressure in 2-phase flow modeling (long)||DS & HB||Main CFD Forum||0||January 8, 2000 16:00|