 |
 |
 |
|
|
|
[Sponsors] | ||||
June 26, 2012, 07:27
|
Wet Combustion
|
#1 |
|
Member
Join Date: Nov 2011
Posts: 42
Rep Power: 15  |
Hi everyone,
When I enable the wet combustion option under Discrete Phase, I was wondering whether I should specify volatiles or the liquid(H2O) as the evaporating species? Its just that the theory guide (devolatilization - law 4), the boiling point and vaporization temperature should be set equal if law 4 (devolatilisation) happens. It then goes on to say that when wet combustion is active, T(bp) and T(vap) refer to the combusting (volatile) material only. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 06:21 |
| error message | cuteapathy | CFX | 14 | March 20, 2012 07:45 |
| WET COMBUSTION | DEV | FLUENT | 0 | August 28, 2008 10:40 |
| Problem with WET COMBUSTION | DEV | FLUENT | 3 | August 27, 2008 01:37 |
| Wet combustion | IgorB | FLUENT | 0 | October 5, 2007 05:17 |
Linear Mode
