|
[Sponsors] |
July 16, 2012, 15:21 |
Contours are not displayed!!!!
|
#1 |
New Member
jeddah boy
Join Date: Jul 2012
Posts: 1
Rep Power: 0 |
hi,
i have made a geometry in GAMBIT and have imported it in Fluent. It gets itterated and solution converges, but the problem arrises when i WRITE the file as CASE & DATA to save it. As i re-open the saved CASE and DATA file the following ERROR massage is displayed ""Note: zone-surface: cannot create surface from sliding interface zone. Creating empty surface"". and in some other cases i get the message Error: Not a pair where i am doing wrong?? |
|
July 17, 2012, 02:18 |
|
#2 |
Member
Join Date: Jul 2012
Posts: 49
Rep Power: 13 |
I think you might have come across the same problem (i mean same error message displayed) when importing mesh file to FLUENT. If it is so, go back to GAMBIT and create the mesh properly with well defined zones. Hope this will help you. By the way in which format are you importing your model in GAMBIT. Try ACIS.
|
|
July 18, 2012, 05:19 |
|
#3 | |
Senior Member
raymond
Join Date: Nov 2009
Posts: 149
Rep Power: 16 |
Quote:
|
||
Tags |
aqstax, federvo.mala |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Fluent] Problem in Mach Contours | Hybrid | FLUENT | 4 | February 13, 2012 02:21 |
About velocity angle when plotting a contours | wateraction | FLUENT | 0 | July 24, 2010 23:24 |
Preconditioning and pressure contours | ganesh | Main CFD Forum | 2 | February 18, 2006 00:02 |
extension for liquid fraction contours | venugopal | FLUENT | 0 | June 11, 2004 01:27 |
contours of F_UDMI | Nici | FLUENT | 8 | September 3, 2003 03:41 |