[Verherezeid]

hi all !!
i have problem when i use fluent on my mesh.....
when i display my grid,, the upper part of my mesh is missing......the upper part should be the pressure inlet......it is control valve geometry......can anyone explain me this problem??

[Marion]

Hi,
Have you selected all the parts you want to display in the mesh display panel?
Are you sure everything is meshed and you exported it correctly from you meshing package?
Marion.

[Verherezeid]

Originally Posted by Marion

Hi,
Have you selected all the parts you want to display in the mesh display panel?
Are you sure everything is meshed and you exported it correctly from you meshing package?
Marion.

thanks anyway....
i found out that it because the missing part didnt get mesh properly
i've tried to mesh that geometry but none of the mesh volume type can be used
now i've got confuse how to mesh that part.....could you tell me how?

[Marion]

Ok, so the part was not lost it was just never there :-)

No I cannot tell you how to mesh your volumes, I am not a psychic ;-)