 |
 |
 |
|
|
|
[Sponsors] | ||||
July 31, 2012, 09:50
|
Conductive/convective heat transfer
|
#1 |
|
New Member
Teyen Widdicombe
Join Date: Jul 2012
Location: UK
Posts: 5
Rep Power: 13  |
I have the following geometry:
geometry.jpg 6 ducts running along a wall in two sections, one (the leaf-shaped bit) hotter than the other. I need to model conduction from the hot surface through the duct walls and then convection inside the ducts, each of which has ten sub-channels. Any idea how I'd go about setting this up in FLUENT? Regardeless of which options I tick I keep getting wall temperatures equivalent to the surface of the sun :| Last edited by Evil Teyen; July 31, 2012 at 09:51. Reason: typo |
|
|
|
|
 |
| Tags |
| conduction, convection, ducts, hot surface |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Two-sided Wall Heat Transfer BC - No Separate Solid Mesh and No Heat Transfer Coeff | swahono | OpenFOAM Running, Solving & CFD | 10 | October 15, 2018 05:43 |
| Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
| Convective / Conductive Heat Transfer in Hypersonic flows | enigma | Main CFD Forum | 2 | November 1, 2009 22:53 |
| How can I increase Heat Transfer at Domain Interf? | B.Simon | CFX | 3 | October 28, 2008 18:53 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Linear Mode
