|
[Sponsors] |
September 12, 2012, 16:05 |
Errror while opening file in Fluent
|
#1 |
Member
Join Date: Sep 2012
Location: FL
Posts: 79
Rep Power: 13 |
I am modelling a simple case in 3D-A room with multiple stacks in it. The geometry of the room is 5x3x7 and stacks are of 0.5X3X7. The inlet of the air flowing in is at the top with rectangular cross section and outlet is at the bottom of the stacks with mesh like cross section. After meshing the fluid, when I try to open the file in Fluent , I am getting this error,
An error occurred in FLUENT when reading model information. The model information may not be compatible with the mesh Could someone suggest me what am I missing here? |
|
September 13, 2012, 03:39 |
|
#2 |
Senior Member
Marion
Join Date: Jul 2012
Location: France
Posts: 122
Rep Power: 14 |
Hi,
Which meshing software are you using? Are you choosing the 3D option in the Fluent startup window? Marion. |
|
September 13, 2012, 12:54 |
|
#3 |
Member
Join Date: Sep 2012
Location: FL
Posts: 79
Rep Power: 13 |
I am using Ansys 12 workbench. So, I guess the meshing software is Ansys Mesh and modelling software is Ansys Modellar. Yes, I am choosing 3D option while opening Fluent.
|
|
September 13, 2012, 17:36 |
|
#4 |
New Member
ugurcan gördük
Join Date: Aug 2012
Location: Turkey
Posts: 4
Rep Power: 13 |
if you use different charecters in the name of surfaces and volumes like (ö,ğ,ü,#,ı) fluent may couldn't read your mesh data
|
|
September 14, 2012, 14:56 |
|
#5 |
Member
Join Date: Sep 2012
Location: FL
Posts: 79
Rep Power: 13 |
I have created only volumes but eventhough I was getting the error. Anways, I did do the geometry in another way and I was able to to open the file without any error. Thanks guys anyways.
|
|
September 20, 2012, 10:35 |
|
#6 |
New Member
jose
Join Date: May 2012
Posts: 5
Rep Power: 13 |
hello
I tell you, I did the same and the problem is to define the shared topology: edge joint, automatic, imprint, none. according to the model you have to make is the use, research on this and will solve the problem. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] mesh airfoil NACA0012 | anand_30 | OpenFOAM Meshing & Mesh Conversion | 13 | March 7, 2022 17:22 |
wmake compiling new solver | mksca | OpenFOAM Programming & Development | 14 | June 22, 2018 06:29 |
Opening a .jou file in FLUENT | Martin_D | FLUENT | 5 | October 12, 2010 10:15 |
OpenFOAM Install Script | ljsh | OpenFOAM Installation | 82 | October 12, 2009 11:47 |
[OpenFOAM] Paraview command not found | hardy | ParaView | 7 | September 18, 2008 04:59 |