 |
 |
 |
|
|
|
[Sponsors] | ||||
February 5, 2018, 06:59
|
Brick mesh in non-sweepable parts
|
#1 |
|
New Member
Join Date: Jul 2017
Posts: 11
Rep Power: 8  |
Hi guys,
I am trying to brick mesh this geometry https://ibb.co/jj25gH. As you can see, I have split the body in several connected volumes which are all sweepable except for the 2 close to the lateral cylinders ( red zones in the pic) . Does anyone have any suggestion about how I can also hex mesh these remaining parts ? |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
| Star CCM Overset Mesh Error (Rotating Turbine) | thezack | Siemens | 7 | October 12, 2016 11:14 |
| [snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
| icem hexa mesh parts pb | jaber | Main CFD Forum | 2 | July 7, 2009 15:30 |
| icem hexa mesh parts pb | jaber | FLUENT | 0 | June 12, 2009 18:06 |
Linear Mode
