 |
 |
 |
|
|
|
[Sponsors] | ||||
October 30, 2012, 09:31
|
Reporting spatial heat flux at boundaries
|
#1 |
|
New Member
Henrik Hofgren
Join Date: Oct 2012
Location: Sweden
Posts: 1
Rep Power: 0  |
Hi everyone!
I'm modeling radiation in participating media. Is there a way to report the spatial heat flux, radiation and total, along walls. I'm new to fluent but as I understand you can only get the heat flux to the entire wall where as is want it as a function of the wall coordinates. I guess that udf's might be needed. Tips on how to write it would most appreciated. Last edited by Skateholmaren; October 30, 2012 at 10:00. Reason: remove thread |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wall Heat Flux & Temperature | Greg Perkins | FLUENT | 10 | November 20, 2015 10:32 |
| Negative Heat Flux | shashank312 | FLUENT | 3 | December 9, 2011 18:00 |
| How to set the Heat Flux boundary condition at Outlet | creddy_trddc | CFX | 3 | September 21, 2011 08:44 |
| heat flux as a function of angle | uncle_salty | FLUENT | 2 | November 11, 2009 19:03 |
| monitoring dynamic heat flux through a surface | abdnakhi | FLUENT | 0 | August 15, 2005 10:57 |
Linear Mode
