|November 12, 2012, 04:57||
Gasification modelling using non-premixed combustion
Join Date: Sep 2012
Posts: 15Rep Power: 6
I'm simulating gasification using Non-Premixed Combustion and DPM. In this forum, I want to ask about my problem.
First, the char conversion 24% (is very low). Do you have any suggestion to get higher conversion by using non-premixed combustion?
I've been simulated this by laminar finite rate model in same test condition (T=367K; P=1atm;Size particle = 25 micrometer; loading factor = 0.933 kg coal/kg gas) and char conversion 99.99%.
Second, can we use wet combustion in Non-Premixed Combustion?
Then, am I right if I think that liquid in wet combustion means water added (not moisture content of coal)?
If I want to inject steam to gasifier, what should I set?
Hopefully your answer. Thanks.
|dpm, non premixed combustion, wet combustion|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Modelling Combustion in Porous Zone||tanjinjack||FLUENT||2||September 26, 2016 04:10|
|Modelling of premixed combustion in a burner rig||ThomasS||FLUENT||9||June 16, 2016 23:12|
|Nonpremixed Combustion Model for Coal Gasification||C.Y.Ler||FLUENT||2||April 29, 2014 08:51|
|Gasification modelling using non-premixed combustion||nurul efha||Main CFD Forum||0||November 8, 2012 05:08|
|Partially Premixed Combustion - Direct Fired Boiler||oknus||FLUENT||0||April 10, 2012 10:52|