|November 12, 2012, 15:26||
Join Date: Apr 2012
Posts: 40Rep Power: 6
I am calculating euler-euler flow (air-bubbles in water tank). I have bubbles with diameter of 50mm while the tank is about 2.5 m in diameter. Someone advised me to use a coarse meash that is abou 100mm x100 mmm as cell cize. I still did not get why?
Now i tried a denser mesh and I observe a significant increase in the "average" rising velocity of aboz factor 2.
Normally I would try an even denser mesh and see if the observed values converge and use this mesh. But how to find a right coarse mesh?
Hopefully some can help me on this discussion.
Thanks in advance!
|Thread||Thread Starter||Forum||Replies||Last Post|
|Compressible flow, no data at the outlet||mireis||FLUENT||6||September 3, 2015 02:10|
|flow over a cylinder urgent!||kevin||FLUENT||8||August 11, 2015 13:00|
|Mass flow and U-Mom flow in CFX||Zhihua Xie||CFX||0||September 3, 2007 09:49|
|transform navier-stokes eq. to euler-eq.||pxyz||Main CFD Forum||37||July 7, 2006 08:42|
|Interaction in bubbly flow||summer||FLUENT||1||June 20, 2006 03:15|