repeat geometry simulation
Hi Guys, firstly this is my first time using this forum so my apologies if this is the wrong section.
i am currently using ansys workbench 14 for some CFD, using fluent. i am running simulations of coolant through radiator tubes, i have the tube modeled, meshed and managed got the results i was looking for for the single tube, my query is whether it is possible to tell ansys to run a simulation with say 30 of these tubes orientated as they would be in a radiator so each inlet inline with around 10mm gap in the z asix. sorry if that is a bit confusing, i hope somebody can help, thank you |
All times are GMT -4. The time now is 18:10. |